Matris değiştirme ve kullanıma hazır işlevselliğe sahip, yüksek performanslı, rafa monte edilebilir 4K60 4:4:4 sunum sistemi. Dört HDMI® girişi ve 4K60 ölçekleyicili bir çift yansıtılmış HDMI ve DM® Essentials çıkışı ve analog ses girişleri ve çıkışları sağlar. HDR (Yüksek Dinamik Aralık) ve Dolby Vision® video formatları, ses karıştırma, gelişmiş EDID yönetimi, XiO Cloud® bağlantısı ve kurumsal düzeyde güvenlik desteğini içerir.
Öne Çıkan Özellikler
- 4K60 4:4:4 dijital AV sunum sistemi
- HDR10, HDR10+ ve Dolby Vision® video formatları
- Otomatik geçişli dört HDMI® girişi
- Bir adet yansıtılmış HDMI ve DM® Essentials çıkışı
- DM Essentials çıktısının HDBaseT® sertifikası
- Yansıtılmış çıkış için 4K60 4:4:4 video ölçekleyici
- Kullanıma hazır işlevsellik
- Kurumsal düzeyde güvenlik
- Ekranda gösterim için metin kaplaması, görüntü kaplaması ve arka plan resmi
- EDID yönetimi
- HDCP 2.3 uyumluluğu
- Ses yerleştirme ve ayırma ile ses karıştırma
- 100BASE-TX/1000BASE-T Ethernet bağlantısı
- USB güç bağlantı noktası
- Uyumlu DM Essentials alıcısıyla kullanıldığında CEC, IR veya RS-232 aracılığıyla cihaz kontrolü
Teknik Özellikler
| Switcher | 4×1 auto-switching or manual, audio‑follows‑video, Crestron Auto-Locking® and QuickSwitch HD™ technologies |
|---|---|
| Scaler (mirrored HDMI and DM Essentials output) | 4K60 4:4:4 video scaler with motion-adaptive deinterlacing, intelligent frame rate conversion; Deep Color support; HDR10, HDR10+, and Dolby Vision support; content‑adaptive noise reduction; and 3:2/2:2 pull‑down detection and recovery |
| Input Signal Types | HDMI with HDR10, HDR10+, and Dolby Vision support, Deep Color support, and 4K60 4:4:4 support (DVI and Dual-Mode DisplayPort™ interface compatible 3 ) |
| Output Signal Types | HDMI, DM Essentials, and HDBaseT with HDR10, HDR10+, and Dolby Vision pass-through support, Deep Color support, and 4K60 4:4:4 support (DVI compatible 4 ) |
| Copy Protection | HDCP 2.3 |
| Maximum Resolutions | Common resolutions are listed in the following table. |
| Audio Inputs | (2) mono, balanced analog MIC/LINE inputs; (2) mono, balanced analog LINE inputs; (1) stereo, digital LPCM audio input extracted from the selected HDMI input source |
| Audio Outputs | (1) mirrored HDMI and DM Essentials audio output; (2) stereo, balanced analog AUX outputs |
| Analog-to-Digital Conversion | 24-bit, 48 kHz |
| Digital-to-Analog Conversion | 24-bit, 48 kHz |
| Input Signal Type | Mono analog, balanced or unbalanced, line-level audio |
| Supported Formats | Dolby Digital®, Dolby Digital EX, Dolby Digital Plus, Dolby® TrueHD, Dolby Atmos®, DTS®, DTS-ES, DTS 96/24, DTS HD® High Res, DTS-HD Master Audio, DTS:X®, LPCM up to 8 channels |
| Gain Range | -10 dB to +10 dB in 1 dB increments |
| Phantom Power | +48VDC, 12mA, enabled or disabled per channel |
| Mute | Enabled or disabled per channel |
| Balanced Line Input Level | 4Vrms |
| Unbalanced Line Input Level | 2Vrms |
| Line Input Impedance | >10 kΩ |
| Output Signal Type | Stereo analog, balanced or unbalanced, line-level audio |
| Formats | Dolby Digital, Dolby Digital EX, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS, DTS-ES, DTS 96/24, DTS HD High Res, DTSHD Master Audio, DTS:X, LPCM up to 8 channels |
| Source Gain | -80 dB to +20 dB adjustment range, plus mute |
| Volume Control | -80 dB to +20 dB adjustment range, plus Mute, mono sum, or stereo output |
| Delay | 0 to 150 ms adjustment range |
| Frequency Response | 20 Hz to 20 kHz ±0.5 dB |
| THD+N | <0.005%, 1 kHz, 4Vrms |
| S/N Ratio | >95 dB, 4Vrms, 20 Hz to 20 kHz, A-weighted |
| Crosstalk | >90 dB, 1 kHz |
| Stereo Separation | >80 dB, 20 Hz to 20 kHz |
| Ethernet | (2) LEDs on RJ-45 LAN connector; Link status LED: Green indicates that a 100BASE-TX link is established, amber indicates that a 1000BASE-T link is established; Ethernet activity LED: Flashing amber indicates Ethernet activity |
| USB | For firmware loading and configuration management and to power a USB powered device |
| HDMI | HDCP 2.3, EDID, CEC |
| HDBaseT | HDCP 2.3 |
| MIC/LINE CH 1-2 | (2) 3-pin 3.5 mm detachable terminal blocks; Balanced mono microphone-level or line-level analog audio inputs |
| LINE INPUT CH 3-4 | (2) 3-pin 3.5 mm detachable terminal blocks; Balanced mono line-level analog audio inputs |
| AUX OUT 1-2 | (2) 5-pin 3.5 mm detachable terminal blocks; Balanced stereo line-level analog audio outputs; Output Impedance: <200 Ω; Maximum Output Level: 4Vrms balanced |
| HDMI INPUTS 1-4 | (4) HDMI Type A connectors, female; HDMI digital audio/video input (DVI and Dual-Mode DisplayPort interface compatible 3 ) |
| DM OUTPUT | (1) 8-pin RJ-45 blue connector, female, shielded; DM Essentials output port (HDBaseT standard compliant) for connection to a DM Essentials receiver, DMPS Essentials switcher, or HDBaseT device; Mirrored with HDMI OUTPUT |
| HDMI OUTPUT | (1) HDMI Type A connector, female; HDMI digital audio/video output (DVI compatible 4 ); Mirrored with DM OUTPUT |
| LAN | (1) 8-pin RJ-45 connector, female; 100BASE-TX/1000BASE-T Ethernet port |
| 100-240VAC 0.7-0.25A 50/60 Hz | (1) IEC 60320 C14 mains power inlet; Removable power cord included NOTE: This power connection powers both the HD-PS401 and the connected DM Essentials receivers. When connected to the HD-PS401 , the DM Essentials receivers must not be connected to power. 5 |
| G | (1) 6-32 screw, chassis ground lug |
| SERVICE | (1) USB 2.0 Type A connector, female; For firmware loading and configuration management; Provides up to 5V, 500mA power to a USB-powered device |
| PWR | (1) bicolor LED; Amber indicates that the device is booting; Green indicates that the device is operational |
| AUTO | (1) Push button to enable or disable automatic switching and (1) green LED to indicate that automatic switching is enabled |
| SETUP | (1) Red LED and (1) push button for display of IP address on connected HDMI and DM Essentials outputs |
| INPUT 1-4 | (4) Push buttons for manual input selection and (4) bicolor LEDs; Green indicates that the corresponding input is routed to an output; Amber indicates that a source is detected at the corresponding input but is not routed to an output |
| DM Essentials | (2) bicolor LEDs on RJ-45 DM Essentials connectors; Green indicates that a DM Essentials link is established; Flashing amber indicates non-HDCP video and solid amber indicates HDCP video |
| Main Power | 100-240VAC, 0.7-0.25A 50/60 Hz NOTE: The AC mains power connection powers both the HD-PS401 and connected DM Essentials receivers. When connected to the HD-PS401 , DM Essentials receivers must not be connected to local power supplies. 5 |
| Power Consumption | 29.2 W typical |
| Temperature | 32° to 104°F (0° to 40°C) |
| Humidity | 10% to 90% RH (noncondensing) |
| Heat Dissipation | 99.6 BTU/hr typical |
| Acoustic Noise | 30 dBA typical |
| Chassis | Metal, black finish, vented sides |
| Mounting | Surface-mountable |
| Height | 1.72 in. (44 mm) |
| Width | 8.66 in. (361 mm) |
| Depth | 10.82 in. (275 mm) |
| DM-CBL-ULTRA DM® Ultra Cable | DM-CBL-8G DM 8G® Cable or CAT5e (UTP) or Higher |
Kullanım Alanları
- Kurumsal ve ticari projelerde switcher (matris) çözümü
- Toplantı odaları, akıllı binalar ve otomasyon sistemlerine entegrasyon
- Profesyonel kurulum ve merkezi yönetim
Sıkça Sorulan Sorular
Crestron HD-PS401 Türkiye’de satılıyor mu?
Evet. Avelkon, Crestron Türkiye yetkili distribütörüdür. Stok, fiyat ve proje teklifi için bizimle iletişime geçebilirsiniz.
Teknik destek ve kurulum sağlanıyor mu?
Evet, yetkili distribütör olarak ürün seçimi, kurulum ve satış sonrası destek sunuyoruz.
Avelkon, Crestron Türkiye yetkili distribütörüdür. Fiyat ve proje teklifi için iletişime geçin.
Değerlendirmeler
Henüz değerlendirme yapılmadı.